INFRARED SAUNA 140 VALERO PRO

The infrared cabin is equipped with Infraheat™ Intense emitters, which provide a good depth effect. The Infraheat™ Intense emitters are installed to work on the back, legs and calves. The Infraheat™ Intense emitters in the back area work on the muscles and nervous system from the lower back to the neck. This part of the spine is where most muscle and joint pain occurs. In the front section of the cabin (left and right or in the front panel), you will find more Infraheat™ Intense emitters that effectively treat knee problems, rheumatic hand pain and osteoarthritis. The last Infraheat™ Intense radiant heater is located behind the calves under the bench seat and is the only radiant heater that can be switched on and off separately.

Furthermore, you get two Infraheat™ Nano-Carbon XL radiators in the side walls. With these Infraheat™ Nano-Carbon XL, you get nice, mild infrared heat for shoulders and neck in a relaxing position. Optionally, this infrared cabin can also be equipped with Infraheat™ Full-spectrum radiators. This is always done in consultation with the customer. The full-spectrum radiator also has a short-wave section, infrared a (IR-A). This wavelength has the fastest, deepest effect and is recommended for rheumatic and arthritic complaints.

In just a few minutes, your cabin is warmed up and ready to use thanks to the patented Infraheat™ technology. The specially developed Infraheat™ Intense radiant heater provides intense heat with a good depth effect to relieve muscle and joint pain. In our quality infrared cabins, people have been experiencing the benefits of this infrared heat for years. The Infraheat™ Intense radiator is a long-wave radiator (IR-C) with transition to medium-wave (IR-B). Experience the wonderful intensive depth effect and feel reborn after every infrared session! This cabin is complemented by two carbon radiators, which provide lovely, mild infrared heat on the shoulders and neck. Thanks to our combination of the different infrared emitters, this cabin has a relieving effect on muscle and joint pain, rheumatic and arthritic complaints and also fibromyalgia.

Choice of wood SuperSauna®

For most models, you can choose between two different types of wood: hemlock or Canadian red cedar (additional cost). Before the wood is finally processed, both types are dried in special drying ovens. This process removes moisture from the wood, which is important so that the wood does not "work" afterwards. Another great advantage of these two types of wood is that they are almost knot- and splinter-free. This makes these woods extremely durable and a purchase for life. Canadian red cedar has another special feature. This wood species has an antibacterial oil, which is fungicidal and bactericidal.

But maintenance is also important. You should wipe the cabin with a damp cloth without detergent after each use. After wiping, simply leave the door open and let the cabin air out. To minimise work and the risk of sweat stains, we recommend using plenty of towels. One towel on the bench, one on the floor and one to take sweat off your body. If you keep sweating permanently during a session, try to cool down your body further and you will continue to sweat freely. For extra hygiene, you can purchase a sauna pillow from us. If you sweat through the towel, the stain will end up on the cushion and not on the wood. Just wipe off the cushion and you're done. No stain in the wood. Once the stain is in the wood, we recommend wiping the area over a large area and letting it air out.

Advantages of SuperSauna® infrared cabins

At SuperSauna®, we strive to provide customers with reliable information and comprehensive advice when purchasing their dream infrared sauna. Our priority is not only the sale, but also the after-sales service. At SuperSauna® we have and give:

Customer satisfaction

Feel free to look at the reviews of customers who are already satisfied owners of a SuperSauna®. Customer review SuperSauna.

Shops in 4 countries

• The largest choice of therapeutic infrared saunas on display
• More than 20 years of experience in selling high-quality infrared cabins
• Shops with a wide range and the best specialist advice (come and see and compare)

Durable Infraheat™ emitters

• Lifetime warranty on Intense and Carbon emitters!
• Always the latest generation of Infraheat™ infrared emitters
• Possibility to combine 3 different types of emitters in one cabin
• Therapeutic Infraheat™ emitters with medium and long wave (optionally also part short wave)

Therapeutic effect

• Relief of muscle and joint pain
• Detox function in the infrared cabin (up to 75°C)

Even more advantages

• Very nice finishing
• Double-walled design
• We only use safety glass
• Including ergonomic backrest
• Hemlock and Canadian red cedar of the best quality
• You can assemble most saunas in 60-90 minutes
• Thanks to the Build-and-Go system, it is also easy to dismantle and move
• Simple and intuitive operation
• Digital control panel inside the infrared cabin
• Audio system with 2 speakers. Radio, Bluetooth and USB function controllable via control panel
• Connection 230 volt, normal socket
• Heated within minutes by the latest Infraheat technology
• Temperature from 35°C up to 75°C degrees, much more pleasant than traditional saunas

Radiator selection at SuperSauna®

At SuperSauna®, we have relied on high-quality infrared emitters from Infraheat™ for more than 15 years. The emitters are tested for 20,000 burning hours. This corresponds to approx. 40,000 sessions. With SuperSauna®, you get a lifetime warranty on these quality infrared emitters.

The most important question you have to ask yourself is: why do I want to buy an infrared cabin?

This reason determines which type of infrared emitters and cabin you should choose. Infrared cabins are used for various reasons.

The most common reasons

• Relief of muscle and joint pain
• Muscle recovery after training
• Reduce stress and relax after a hard day
• Strengthen your immune system
• Skin diseases
• Train heart rhythm
• Lyme disease
• Improve sleep
• Burn calories
• Detox / Purify

Short-wave infrared (wavelength 750nm - 1400nm)

The shorter the wavelength of infrared, the more heat is caused on the skin and the shorter you can use it. This makes it difficult for our body to properly absorb this type of infrared radiation. This form of infrared radiation has the advantage that it penetrates slightly deeper into our body. For this reason, early clinical trials (before 1998) were predominantly positive about this type of short-wave infrared radiation. However, later studies concluded that long-wave infrared radiation has advantages. The average usage time of the short-wave is only about 10 minutes per session.

Long-wave infrared (wavelength 3000nm - 10,000nm)

The long-wave infrared radiation goes slightly less deep than the short-wave, but is much better absorbed by our body. For this reason, the best therapeutic results are usually achieved with this type of infrared emitter. For deeper pain (for example, a hernia), the use of a short-wave emitter can be beneficial. In the SuperSauna® specialist shop, we will be happy to explain how you can optimally use the combination of the different heaters.

Absorption more important than depth!

In the past, the emphasis was mainly on the depth effect of infrared. Later, however, it was discovered that infrared absorption is much more important. Because this largely determines the therapeutic effect. As a result, most clinical studies* (after 2002) support long-wave infrared more than short-wave infrared.

Infraheat™ Intense

For years, we have been using emitters from the Infraheat™ brand. These emitters have been specially developed for relieving muscle and joint pain. The emitter is a long-wave emitter with a transition to the medium-wave and is made of a special ceramic magnesium oxide material. Because the Infraheat™ Intense generates medium-wave infrared in addition to the long-wave, this radiation has a good depth effect on the body. This depth effect is important for relieving muscle and joint pain. Infraheat™ is a reliable choice with years of proven performance.

Infraheat™ Carbon

Carbon emitters are known for the nice, mild heat in the infrared sauna. We use the Infraheat Carbon emitters in combination with the Infraheat Intense emitters to create a perfect heat balance in the IR cabin. The Infraheat Carbon emitters are usually placed as a supplement in the side walls of the IR cabin. As a result, you experience wonderful infrared heat on all sides of your body and still get a mild heat on your back in a relaxed position. This unique combination of emitters ensures a unique infrared experience that is unique in Europe.

Infraheat™ Full Spectrum

Infraplus makes it possible to equip your cabin with Infraheat full-spectrum emitters (optional). This means you not only have medium and long-wave infrared heat but also a portion of short-wave (IR-A). In consultation with the customer, we ensure the perfect balance in your IR sauna. The full-spectrum emitters can be placed according to customer-specific wishes, so that a suitable configuration is possible for everyone.

Installation of your SuperSauna®

Assembly is kept very simple by prefabricated elements and is also feasible for a layman. You only have to put 9 parts together. You can do this easily with our clear assembly instructions. The points where benches, backrests and other parts must be attached are already pre-assembled. You no longer have to measure anything. Just hang and screw.

Installing accessories

Colour therapy lamps: The colour therapy lamp is attached to the inside of the roof. All you have to do is drill a hole for the cable and screw the panel lamp in place with 4 hooks. Do not cut and let in, just put it on.

Full-spectrum emitter: Place the full-spectrum emitter instead of an intense emitter. To do this, remove the built-in intense emitter and replace it with the full-spectrum emitter.

Underfloor heating: The underfloor heating is placed on the floor. You have to drill a hole in the calf emitter plate so that the cable is not pinched and connect it to the back wall with a Y-connector.

Here you can see how all SuperSauna cabins are installed. The video shown is about the 2 Trendy.